Humanscale QuickStand Manuel d'utilisateur

INSTALLATION INSTRUCTIONS

10STEP 15Adjusting Monitor TiltSINGLE AND DUAL QUICKSTAND• Hold the top and bottom of your monitor and manually adjust the monitor tilt until the d

www.humanscale.comHSRI0514Customer Service: N America +1 800 400 0625 / International +353 (0)1 858 0910

PARTS REQUIREDSingle QuickStand PartsA (1) QuickStand UnitB (1) Base PlateC (1) PlatformD (1) Palm SupportE (1) VESA PlateF (6) M8 x 18 mm Flat

3STEP 1Remove Shipping PlateTools: 6 mm Hex Key• Lay the QuickStand unit on the work surface facing up and unscrew the (2) M8 x 10 mm Cap Head Machi

4STEP 4Measure Work Surface Depth IMPORTANT: Please check the depth of your work surface - If you are installing a QuickStand with a Large Platform

5STEP 6Attaching QuickStand to the Work SurfaceIMPORTANT: Your QuickStand unit is heavy. If needed, please have assistance when lifting.• Carefull

6STEP 8Attaching Crossbar for Dual Monitors Tools: 3 mm Hex Key 4 mm Hex Key• Attach Dual Monitor Crossbar to QuickStand unit using the hardware ki

7ST EP 11Attaching USB DevicesTools: Flat-Head Screwdriver• Using a Flat-Head Screwdriver if needed, remove cable cover by tilting out from the bott

8STEP 12Removing Brace Box • Remove tape and lift out box. (fig. Q)STEP 13Adjusting Weight Capacity WARNING: Do not use a Power Drill to adjust the te

9STEP 14Adjusting Monitor HeightSINGLE QUICKSTAND• Hold each side of your monitor and manually raise or lower until it is in the correct position (fi