Humanscale QuickStand Manuel d'utilisateur télécharger pdf (Page 4)

STEP 4

Measure Work Surface Depth

IMPORTANT: Please check the depth of your work surface

- If you are installing a QuickStand with a Large Platform, your QuickStand

is pre-set to attach to a 29” (750 mm) deep work surface

- If you are installing a QuickStand with a Small Platform, your QuickStand

is pre-set to attach to a 23” (600 mm) deep work surface

Tools: Measuring Tape

• The distance between the front edge of the Platform to

the inside face of the Base Clamp must be equal to the

work surface depth (ﬁg. D)

• If the Base Clamp is in the correct position, please proceed to step 6

• If the Base Clamp needs to be adjusted, please proceed to step 5

STEP 5

Adjust Base Clamp for Correct Work Surface Depth

Tools: Measuring Tape

5 mm Hex Key

• Loosen or remove the (4) M8 x 10 mm Pan Head Machine

Screws and slide/reposition the Base Clamp to achieve the

correct work surface depth (ﬁg. E)

STEP 3

Attach Platform

Tools: 6 mm Hex Key

• Ensure the Platform is equally spaced from

the Base Plate on either side (ﬁg. C)

• Using the (2) M8 x 10 mm Cap Head Machine

Screws and the Washers from step 1, secure

the Platform to the QuickStand unit

Base Plate

Platform

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Humanscale QuickStand Manuel d'utilisateur Page 4